openwrt/package/boot
Chris Blake 949e8ba521 ath79: add support for Netgear PGZNG1
This adds support for the Netgear PGZNG1, also known as the ADT Pulse
Gateway.

Hardware:
CPU: Atheros AR9344
Memory: 256MB
Storage: 256MB NAND Hynix H27U2G8F2CTR-BC
USB: 1x USB 2.0
Ethernet: 2x 100Mb/s
WiFi: Atheros AR9340 2.4GHz 2T2R
Leds: 8 LEDs
Button: 1x Reset Button
UART:
Header marked JPE1. Pinout is VCC, TX, RX, GND. The marked pin, closest
to the JPE1 marking, is VCC. Note VCC isn't required to be connected
for UART to work.

Enable Stock Firmware Shell Access:
1. Interrupt u-boot and run the following commands
setenv console_mode 1
saveenv
reset

This will enable a UART shell in the firmware. You can then login using
the root password of `icontrol`. If that doesn't work, the device is
running a firmware based on OpenWRT where you can drop into failsafe to
mount the FS and then modify /etc/passwd.

Installation Instructions:
1. Interupt u-boot and run the following commands
setenv active_image 0
setenv stock_bootcmd nboot 0x81000000 0 \${kernel_offset}
setenv openwrt_bootcmd nboot 0x82000000 0 \${kernel_offset}
setenv bootcmd run openwrt_bootcmd
saveenv

2. boot initramfs image via TFTP u-boot
tftpboot 0x82000000 openwrt-ath79-nand-netgear_pgzng1-initramfs-kernel.bin; bootm 0x82000000

3. Once booted, use LuCI sysupgrade to
flash openwrt-ath79-nand-netgear_pgzng1-squashfs-sysupgrade.bin

MAC Table:
WAN (eth0): xx:xa - caldata 0x0
LAN (eth1): xx:xb - caldata 0x6
WLAN (phy0): xx:xc - burned into ath9k caldata

Not Working:
Z-Wave
RS422

Signed-off-by: Chris Blake <chrisrblake93@gmail.com>
(added more hw-info, fixed file permissions)
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
2022-06-19 12:31:02 +02:00
..
arm-trusted-firmware-bcm63xx arm-trusted-firmware-bcm63xx: add ATF for Broadcom devices 2021-12-24 22:42:03 +01:00
arm-trusted-firmware-mediatek arm-trusted-firmware-mediatek: remove no longer needed Configure step 2022-04-09 22:24:42 +01:00
arm-trusted-firmware-mvebu
arm-trusted-firmware-rockchip
arm-trusted-firmware-sunxi
arm-trusted-firmware-tools
at91bootstrap at91: add support for sama7g5-ek board 2022-02-24 19:05:29 +01:00
fconfig
grub2 grub2: add missing license 2022-04-04 18:15:02 +02:00
imx-bootlets
kexec-tools
kobs-ng
mt7623n-preloader
tfa-layerscape layerscape: use semantic versions for LSDK 2022-03-01 00:01:18 +01:00
uboot-at91 at91: add support for sama7g5-ek board 2022-02-24 19:05:29 +01:00
uboot-bcm4908 uboot-bcm4908: add BCM4912 build 2022-03-15 18:43:41 +01:00
uboot-envtools ath79: add support for Netgear PGZNG1 2022-06-19 12:31:02 +02:00
uboot-fritz4040 uboot-fritz4040: Add support for Toshiba NAND 2022-05-14 11:08:45 +02:00
uboot-imx uboot-imx: fix wrong make flags overriding 2022-05-28 14:32:40 +02:00
uboot-kirkwood
uboot-lantiq
uboot-layerscape layerscape: use semantic versions for LSDK 2022-03-01 00:01:18 +01:00
uboot-mediatek uboot-mediatek: update UniFi 6 LR board name 2022-06-16 19:56:12 +01:00
uboot-mvebu uboot-mvebu: update to version v2022.04 2022-05-01 00:42:30 +02:00
uboot-mxs
uboot-omap
uboot-oxnas
uboot-ramips
uboot-rockchip uboot-rockchip: drop CONFIG_IDENT_STRING 2022-06-19 12:31:02 +02:00
uboot-sunxi
uboot-tegra
uboot-zynq