openwrt/target/linux/mediatek/dts
David Bauer c9cb6411c1 mediatek: add support for Cudy WR3000 v1
Hardware
--------
MediaTek MT7981 WiSoC
256MB DDR3 RAM
16MB SPI-NOR (XMC XM25QH128C)
MediaTek MT7981 2x2 DBDC 802.11ax 2T2R (2.4 / 5)
UART: 115200 8N1 3.3V
      [LEDS] VCC-GND-RX-TX [ETH]
      Header is located below the heatsink

Case
----
Unscrew the 4 bottom screws. Remove the top of the case by inserting a
small screwdriver into the ventilation holes and lift the top cover.

This works best by beginning near the ETH-ports. The top is clipped on
the front near the LEDs with two plastic clips. The back has a single
clip in the middle. Start at one of the back edges.

MAC-Addresses
-------------
80:AF:CA:00:F9:C6 LAN
80:AF:CA:00:F9:C7 WAN
80:AF:CA:00:F9:C6 W2
82:AF:CA:30:F9:C6 W5

Installation
------------

1. Connect to the serial port as described in the "Hardware" section.

2. Power on the device. Keep pressing the "0" key to enter the U-Boot
   shell.

3. Download the OpenWrt initramfs image. Place it on an TFTP server
   connected to the Cudy LAN ports. Make sure the server is reachable at
   192.168.1.2. Rename the image to "cudy3000.bin"

4. Download and boot the OpenWrt initramfs image.

   $ tftpboot 0x46000000 cudy3000.bin; bootm 0x46000000

5. Transfer the OpenWrt sysupgrade image to the device using scp.
   Install with sysupgrade.

Note: Cudy does not yet provide a image for disabling their
signature-protection. This has happened in the past. Make sure to check
the wiki for a possible easier installation method.

Signed-off-by: David Bauer <mail@david-bauer.net>
2023-05-18 01:46:13 +02:00
..
mt7622-buffalo-wsr-2533dhp2.dts
mt7622-elecom-wrc-2533gent.dts
mt7622-elecom-wrc-x3200gst3.dts treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7622-linksys-e8450-ubi.dts
mt7622-linksys-e8450.dts
mt7622-linksys-e8450.dtsi treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7622-netgear-wax206.dts mediatek: no longer hard-code WAN PHY of Netgear WAX206 2023-04-30 17:27:00 +01:00
mt7622-reyee-ax3200-e5.dts mediatek: also move &slot0 from dtsi down to board dts 2022-12-07 01:45:14 +00:00
mt7622-rfb1-ubi.dts
mt7622-ruijie-rg-ew3200.dtsi treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7622-ruijie-rg-ew3200gx-pro.dts mediatek: also move &slot0 from dtsi down to board dts 2022-12-07 01:45:14 +00:00
mt7622-totolink-a8000ru.dts
mt7622-ubnt-unifi-6-lr-v1-ubootmod.dts mediatek: mt7622: fix DTS compatible of UniFi 6 LR variants 2022-09-03 02:27:59 +01:00
mt7622-ubnt-unifi-6-lr-v1.dts mediatek: mt7622: fix DTS compatible of UniFi 6 LR variants 2022-09-03 02:27:59 +01:00
mt7622-ubnt-unifi-6-lr-v1.dtsi mediatek: fix ledbar of UniFi 6 LR when running custom U-Boot 2022-09-11 20:26:42 +01:00
mt7622-ubnt-unifi-6-lr-v2-ubootmod.dts mediatek: mt7622: fix DTS compatible of UniFi 6 LR variants 2022-09-03 02:27:59 +01:00
mt7622-ubnt-unifi-6-lr-v2.dts
mt7622-ubnt-unifi-6-lr-v2.dtsi
mt7622-ubnt-unifi-6-lr.dtsi
mt7622-xiaomi-redmi-router-ax6s.dts treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7623a-unielec-u7623-02-emmc-512m.dts
mt7623a-unielec-u7623-02.dts
mt7623a-unielec-u7623-02.dtsi treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7629-iptime-a6004mx.dts treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00
mt7981b-cudy-wr3000-v1.dts mediatek: add support for Cudy WR3000 v1 2023-05-18 01:46:13 +02:00
mt7986a-asus-tuf-ax4200.dts mediatek: apply stock configuration for WAN-LED 2023-05-11 23:09:04 +02:00
mt7986a-bananapi-bpi-r3-emmc-nor.dts
mt7986a-bananapi-bpi-r3-emmc-snand.dts
mt7986a-bananapi-bpi-r3-nor.dts
mt7986a-bananapi-bpi-r3-snand.dts
mt7986a-bananapi-bpi-r3.dts mediatek: bpi-r3: allow up to 3W per SFP module 2023-04-20 01:03:56 +01:00
mt7986a-tplink-tl-xdr4288.dts mediatek: add support for TP-Link TL-XDR4288/608x 2023-04-22 04:10:19 +01:00
mt7986a-tplink-tl-xdr6086.dts mediatek: add support for TP-Link TL-XDR4288/608x 2023-04-22 04:10:19 +01:00
mt7986a-tplink-tl-xdr6088.dts mediatek: add support for TP-Link TL-XDR4288/608x 2023-04-22 04:10:19 +01:00
mt7986a-tplink-tl-xdr-common.dtsi mediatek: add support for TP-Link TL-XDR4288/608x 2023-04-22 04:10:19 +01:00
mt7986a-xiaomi-redmi-router-ax6000-stock.dts mediatek: add new layout for Xiaomi Redmi Router AX6000 for OpenWrt U-Boot 2022-12-29 03:00:31 +00:00
mt7986a-xiaomi-redmi-router-ax6000-ubootmod.dts mediatek: add new layout for Xiaomi Redmi Router AX6000 for OpenWrt U-Boot 2022-12-29 03:00:31 +00:00
mt7986a-xiaomi-redmi-router-ax6000.dtsi treewide: remove label = "cpu" from DSA dt-binding 2023-02-26 22:22:48 +01:00