ramips: add support for ELECOM WMC-S1267GS2
ELECOM WMC-S1267GS2 is a 2.4/5 GHz band 11ac (Wi-Fi 5) mesh extender,
based on MT7621A.
This device has almost the same hardware as WMC-M1267GST2.
Specification:
- SoC : MediaTek MT7621A
- RAM : DDR3 256 MiB (Nanya NT5CC128M16JR-EK)
- Flash : SPI-NOR 32 MiB (Winbond W25Q256JVFIQ)
- WLAN : 2.4/5 GHz 2T2R (MediaTek MT7615D)
- Ethernet : 10/100/1000 Mbps x4
- switch : MediaTek MT7530 (SoC)
- LEDs/Keys : 6x/6x
- UART : through-hole on PCB ("J4")
- arrangement: 3.3V, GND, TX, RX from tri-angle marking
- settings : 57600n8
- Power : 12 VDC, 1 A
Flash instruction using factory image:
1. Boot WMC-S1267GS2 normally
2. Set IP address of the computer to 192.168.2.x
3. Access to "http://192.168.2.1/" and open firmware update page
("ファームウェア更新")
4. Select the OpenWrt factory image and click apply ("適用") button
5. Wait ~120 seconds to complete flashing
MAC addresses:
LAN : 04:AB:18:xx:xx:9E (Factory, 0xFFF4 (hex))
2.4 GHz: 04:AB:18:xx:xx:9F
5 GHz : 04:AB:18:xx:xx:A0 (Factory, 0x4 (hex))
Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
61e8728d86