cehoyos adds the step_property command in 7a71da01d, and it could be
argued that copyright of this still applies to the later add/cycle
commands (a668ae0ff9). While I'm not sure if this is really the case,
stay conservative for now and mark these commands as GPL-only. Mark the
command.c code too, although that is not being relicensed yet.
I'm leaving the MP_CMD_* enum items, as they are obviously different.
In commit 116ca0c768, "veal" (essentially an anonymous author) adds an
"osd_show_property_text" command (well, the commit message says "based
on" that person's code, so it's not clear how much is from him or from
albeu, who agreed to LGPL). This was later merged again with the
"osd_show_text" command, and then all original code was removed in
commit 58cc0f637f, so I claim that no copyright applies anymore. (Though
technically the input.conf addition still might be copyrighted, so I'm
just dropping it to get rid of the thought.)
"kiriuja" added 2f376d1b39 (sub_load etc.) and be54f4813 (switch_audio).
The latter is gone. I would argue that the former is fully rewritten
with commits b7052b431c and 0f155921b0. But like in the step_property
case, I will be overly conservative for now, and mark them as GPL-only,
as this is potentially shaky and should be thought through first. (Not
bothering with the command define/enum in the header, as it will be
unused in LGPL mode anyway.)
keycodes.c/h can be GPL, except for commit 2b1f95dcc2, which is a
patch by someone who wasn't asked yet. Before doing something radical, I
will wait for a reply.
Old-style commands using _ as separator (e.g. show_progress) were still
used in some places, including documentation and configuration files.
This commit updates all such instances to the new style (show-progress)
so that commands are easier to find in the manual.
Drop d for toggling framedrop. Toggling this is way too special to be at
such a prominent place, and in fact I believe toggling it is pointless.
Remap deinterlacing from D to d. It's relatively useful and non-
destructive.
As suggested in #973 (almost).
The "osd" command cycles between 4 states (OSD level 0-3), which is
probably confusing and inconvenient. OSD levels 0 and 2 are rarely
needed. I would claim there is normally not much of a need to completely
disable OSD by setting level 0 during playback. Level 2 is just slightly
less information than level 3, and I'm not sure why it exists at all.
Change it so that it toggles between level 3 and 1. Note that this
ignores the default OSD level. If the default is 3, the first use of
this key will set it to 3 again. Just assume 1 is the default. If
someone complains, this could be improved.
This is for users who don't like changes. I'm hoping it will make the
process of cleaning up key bindings less bumpy.
It should be mentioned in the release notes of the next release.
James Ross-Gowan
wm4
Timotej Lazar