With the CI occasionally slowing down, we're starting to see again some
spurious failures despite the long 1-second timeouts. This reports false
positives that are disturbing and doesn't provide as much value as this
could. However at this delay it already becomes a pain for developers
to wait for the tests to complete.
This commit adds support for the new environment variable
HAPROXY_TEST_TIMEOUT that will allow anyone to modify the connect,
client and server timeouts. It was set to 5 seconds by default, which
should be plenty for quite some time in the CI. All relevant values
that were 200ms or above were replaced by this one. A few larger
values were left as they are special. One test for the set-timeout
action that used to rely on a fixed 1-sec value was extended to a
fixed 5-sec, as the timeout is normally not reached, but it needs
to be known to compare the old and new values.
This test was dependent on the check/server timeout to detect a failure,
which is not logical since we also use that one as an upper bound for
success in the second test, and that needlessly extends the test duration.
Let's make sur the timeout strikes immediately with only 1 ms timeout. Now
the total tests time is around 5.3-5.4s down from 8.7s in dev14. There is
still quite some room for improvement in the peers tests which all wait 2s
before starting but this will be more complicated.
Its sole remaining purpose was to display "proxy foo started", which
has little benefit and pollutes output for those with plenty of proxies.
Let's remove it now.
The VTCs were updated to reflect this, because many of them had explicit
counts of dropped lines to match this message.
This is tagged as MEDIUM because some users may be surprized by the
loss of this quite old message.
Some expect rules cannot be satisfied due to inherent ambiguity towards
the received data: in the absence of match, the current behavior is to
be forced to wait either the end of the connection or a buffer full,
whichever comes first. Only then does the matching diagnostic is
considered conclusive. For instance :
tcp-check connect
tcp-check expect !rstring "^error"
tcp-check expect string "valid"
This check will only succeed if the connection is closed by the server before
the check timeout. Otherwise the first expect rule will wait for more data until
"^error" regex matches or the check expires.
Allow the user to explicitly define an amount of data that will be
considered enough to determine the value of the check.
This allows succeeding on negative rstring rules, as previously
in valid condition no match happened, and the matching was repeated
until the end of the connection. This could timeout the check
while no error was happening.
[Cf: I slighly updated the patch. The parameter was renamed and the value is a
signed integer to support -1 as default value to ignore the parameter.]
