From kernel 3.3 onwards, btrfs balance can limit its action to a subset of the whole filesystem, and can be used to change the replication configuration (e.g. moving data from single to RAID1). This functionality is accessed through the *-d*, *-m* or *-s* options to btrfs balance start, which filter on data, metadata and system blocks respectively. A filter has the following structure: *type[=params][,type=...]* The available types are: profiles= Balances only block groups with the given profiles. Parameters are a list of profile names separated by "*|*" (pipe). usage=, usage= Balances only block groups with usage under the given percentage. The value of 0 is allowed and will clean up completely unused block groups, this should not require any new work space allocated. You may want to use *usage=0* in case balance is returning ENOSPC and your filesystem is not too full. The argument may be a single value or a range. The single value *N* means *at most N percent used*, equivalent to *..N* range syntax. Kernels prior to 4.4 accept only the single value format. The minimum range boundary is inclusive, maximum is exclusive. devid= Balances only block groups which have at least one chunk on the given device. To list devices with ids use **btrfs filesystem show**. drange= Balance only block groups which overlap with the given byte range on any device. Use in conjunction with *devid* to filter on a specific device. The parameter is a range specified as *start..end*. vrange= Balance only block groups which overlap with the given byte range in the filesystem's internal virtual address space. This is the address space that most reports from btrfs in the kernel log use. The parameter is a range specified as *start..end*. convert= Convert each selected block group to the given profile name identified by parameters. .. note:: Starting with kernel 4.5, the *data* chunks can be converted to/from the *DUP* profile on a single device. .. note:: Starting with kernel 4.6, all profiles can be converted to/from *DUP* on multi-device filesystems. limit=, limit= Process only given number of chunks, after all filters are applied. This can be used to specifically target a chunk in connection with other filters (*drange*, *vrange*) or just simply limit the amount of work done by a single balance run. The argument may be a single value or a range. The single value *N* means *at most N chunks*, equivalent to *..N* range syntax. Kernels prior to 4.4 accept only the single value format. The range minimum and maximum are inclusive. stripes= Balance only block groups which have the given number of stripes. The parameter is a range specified as *start..end*. Makes sense for block group profiles that utilize striping, ie. RAID0/10/5/6. The range minimum and maximum are inclusive. soft Takes no parameters. Only has meaning when converting between profiles. When doing convert from one profile to another and soft mode is on, chunks that already have the target profile are left untouched. This is useful e.g. when half of the filesystem was converted earlier but got cancelled. The soft mode switch is (like every other filter) per-type. For example, this means that we can convert metadata chunks the "hard" way while converting data chunks selectively with soft switch. Profile names, used in *profiles* and *convert* are one of: *raid0*, *raid1*, *raid1c3*, *raid1c4*, *raid10*, *raid5*, *raid6*, *dup*, *single*. The mixed data/metadata profiles can be converted in the same way, but it's conversion between mixed and non-mixed is not implemented. For the constraints of the profiles please refer to ``mkfs.btrfs(8)``, section *PROFILES*.